WindEnergyClamps by Weique / Core product · Cable fixing · Lightweight tower routes
TOWER · ALUMINUM · IEC 61914
Aluminum Trefoil Cable Cleat
A lightweight three-phase cable cleat for wind turbine tower and onshore routes where reduced mass, fast installation and corrosion resistance need to be balanced.
Best fitTower-internal and onshore routes where low mass matters
Required inputCable OD, fault current, spacing, mounting and environment
Supply definitionMarine-grade aluminum body, stainless hardware and protective liner
Next stepCompare aluminum with SS316 before specification release
Typical applications
- Tower internal power cable support
- Onshore wind cable routing where weight reduction helps installation
- Cable routes needing non-magnetic or low-mass cleat bodies
- Projects where stainless steel is not necessary but polymer cleats are not preferred
Selection notes
Aluminum trefoil cleats are often considered when installation teams need a more rigid body than polymer cleats without the full weight and cost of stainless steel.
The material choice must still be checked against the short-circuit duty and environment. For single-core AC cable routes, magnetic behavior, heat build-up and cable sheath protection should be reviewed before release.
RFQ checklist
- Cable outside diameter
- Peak and RMS short-circuit current
- Support pitch
- Tower or onshore mounting details
- Preferred fastener and liner material
Send the project data and we will review the selection by zone, material and documentation requirement.
Check aluminum cleat size →